Cisco 7604-RSP720C-R User Manual

Send document comments to nexus7k-docfeedback@cisco.com
2-15
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
OL-23435-03
Chapter 2 Configuring Basic Interface Parameters
Configuring the Basic Interface Parameters
• Configuring the MTU Size, page 2-31
• Configuring the Bandwidth, page 2-34
• Configuring the Throughput Delay, page 2-36
• Shutting Down and Activating the Interface, page 2-37
• Configuring the UDLD Mode, page 2-39
• Configuring the Carrier Delay Timer, page 2-41
• Configuring Port Profiles, page 2-43
• Performing TDR Cable Diagnostics, page 2-51
• Configuring Rate Limits for Packets that Reach the Supervisor, page 2-52
Specifying the Interfaces to Configure
Before you can configure the parameters for one or more interfaces of the same type, you must specify
the type and the identities of the interfaces.
Table 2-6 shows the interface types and identities that you should use for specifying the Ethernet and
management interfaces.
The interface range configuration mode allows you to configure multiple interfaces with the same
configuration parameters. After you enter the interface range configuration mode, all command
parameters you enter are attributed to all interfaces within that range until you exit out of the interface
range configuration mode.
You enter a range of interfaces using dashes (-) and commas (,). Dashes separate contiguous interfaces
and commas separate noncontiguous interfaces. When you enter noncontiguous interfaces, you must
enter the media type for each interface.
The following example shows how to configure a contiguous interface range:
switch(config)# interface ethernet 2/29-30
switch(config-if-range)#
The following example shows how to configure a noncontiguous interface range:
switch(config)# interface ethernet 2/29, ethernet 2/33, ethernet 2/35
switch(config-if-range)#
You can specify subinterfaces in a range only when the subinterfaces are on the same port, for example,
2/29.1-2. But you cannot specify the subinterfaces in a range of ports, for example, you cannot enter
2/29.2-2/30.2. You can specify two of the subinterfaces discretely, for example, you can enter 2/29.2,
2/30.2.
SUMMARY STEPS
1. configure terminal
Table 2-6 Information Needed to Identify an Interface for Configurations
Interface Type Identity
Ethernet I/O module slot numbers and port numbers on the module
Management 0 (for port 0)

Cisco 7604-RSP720C-R Specifications

General

Brand	Cisco
Model	7604-RSP720C-R
Category	Recording Equipment
Language	English