Cisco 7906G Phone Guide

Basic Call Handling
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.1 23
Using Conference
Conference allows you to call each participant. Conference is available on most phones.
If you want to... Then...
Create a conference by calling
participants
1. From a connected call, press Confrn.
2. Enter the participant’s phone number.
3. Wait for the call to connect.
4. Press Confrn again to add the participant to your call.
5. Repeat to add additional participants.
Add new participants to an
existing conference
Repeat the steps listed above.
Your system administrator determines whether non-initiators of a
conference can add or remove participants.
See a list of participants or
remove participants
See Viewing or Removing Conference Participants, page 25.
Using Join
(SCCP phones only)
Join allows you to combine two or more existing calls to create a conference in which you are a
participant.
If you want to... Then...
Create a conference by joining
together existing calls
1. From an active call, highlight another call that you want to
include in the conference and press Select.
Selected calls display this icon .
2. Repeat this step for each call that you want to add.
3. Press Join. (You may need to press the more softkey to see Join.)
Join together two existing
conferences
Use the Join or DirTrfr softkeys.
Check with your system administrator to see if this feature is
available to you.
See a list of participants or
remove participants
See Viewing or Removing Conference Participants, page 25.

Cisco 7906G Specifications

General

Brand	Cisco
Model	7906G
Category	IP Phone
Language	English