24 OL-14584-01
Using cBarge
You can create a conference by using cBarge to add yourself to a call on a shared line.
If you want to... Then...
Create a conference by
barging a call on a shared line
Highlight the call and press cBarge to complete the action.
See Using a Shared Line, page 29 for more information.
See a list of participants or
remove participants
See Viewing or Removing Conference Participants, page 25.
Using Meet-Me
Meet-Me conferencing allows you to start or join a conference by calling the conference number.
If you want to... Then...
Start a Meet-Me conference 1. Obtain a Meet-Me phone number from your system administrator.
2. Distribute the number to participants.
3. When you are ready to start the meeting, go off-hook to get a dial
tone, then press MeetMe.
4. Dial the Meet-Me conference number.
Participants can now join the conference by dialing in.
Note Participants hear a busy tone if they call the conference before the
initiator has joined. In this case, participants must call back.
Join a Meet-Me conference Dial the Meet-Me conference number (provided by the conference
initiator).
Note You will hear a busy tone if you call the conference before the
initiator has joined. In this case, try your call again.
End a Meet-Me conference All participants must hang up.
The conference does not automatically end when the conference
initiator disconnects.
Tip
If you call a secure Meet-Me conference number from a non-secure phone, your phone displays the
message, “Device Not Authorized.” For more information, see
Making and Receiving Secure Calls,
page 31.
To Next Page
Loading...
Need help?
General
