72 OL-15163-01
Cisco Unified Communications Manager Release 5.1 and Later
This section describes how to set up and use Personal Directory on your phone when you are connected
to a Cisco Unified Communications Manager 5.0 or later. Alternately, see
Using Personal Directory on
the Web, page 84.
If you want to... Then...
Access Personal
Directory (for PAB
and Fast Dial codes)
1. Choose (Directory) > Directory Services > Personal Address
Book (PAB) Service (exact name may vary).
2. Enter your Cisco Unified Communications Manager user ID and PIN,
then press Options > Submit.
Search for a PAB
entry
1. Access Personal Address Book.
2. Enter search criteria and choose Options > Submit.
Note To get a complete list of your PAB entries, do not enter any search criteria,
and choose Options > Submit.
3. You can choose Options > Previous or Next to move through listings.
4. Scroll to the PAB listing that you want and press Select or .
Dial from PAB entry 1. Search for a PAB entry.
2. Scroll to the listing and press Select or .
3. Press Dial.
4. Scroll to the number that you want to dial and press OK.
5. Press OK again to dial the number.
Delete a PAB entry 1. Search for a PAB entry.
2. Scroll to the listing and press Select or .
3. Choose Options >Delete.
4. Press OK to confirm the deletion or Cancel.
Edit a PAB entry 1. Search for a PAB entry.
2. Scroll to the listing and press Select or .
3. Choose Options > Edit to modify a name or mail address.
4. If necessary, choose Options > Phones to modify a phone number.
5. Press Update.
To Next Page
Loading...
Need help?
General
