Cisco 7931G Installation Instructions

Procedure
Step 1
Remove the handset from the cradle and pull the plastic tab from the handset rest.
Step 2
Rotate the tab 180 degrees.
Step 3
Hold the tab between two fingers, with the corner notches facing you.
Step 4
Line up the tab with the slot in the cradle and press the tab evenly into the slot. An extension protrudes from
the top of the rotated tab.
Step 5
Return the handset to the handset rest.
TAPS Registration
TAPS might be used either for a new phone or to replace an existing phone. To register with TAPS, pick up
the handset, enter the TAPS extension provided by your system administrator, and follow the voice prompts.
You might need to enter your entire extension, including the area code. After your phone displays a confirmation
message, hang up. The phone restarts.
Headset Support
Although Cisco Systems performs limited internal testing of third-party headsets for use with the Cisco Unified
IP Phones, Cisco does not certify or support products from headset (or handset) vendors.
Cisco recommends the use of good quality headsets that are screened against unwanted radio frequency (RF)
and audio frequency (AF) signals. Depending on the quality of the headsets and their proximity to other
devices such as mobile phones and two-way radios, some audio noise or echo may still occur. An audible
hum or buzz may be heard by either the remote party or by both the remote party and the Cisco Unified IP
Cisco Unified IP Phone 7931G User Guide for Cisco Unified Communications Manager 9.0 (SCCP and SIP)
3
Phone Installation
TAPS Registration

Cisco 7931G Specifications

General

Mounting	Desk/Wall
Handset type	Wired handset
Product type	IP Phone
Product color	Black
Wall mountable	Yes
Electromagnetic compatibility	FCC Part 15 (CFR 47) Class B, ICES-003 Class B, EN55022 Class B, CISPR22 Class B, AS/NZS CISPR 22 Class B, CISPR 24, VCCI Class B, EN55024, EN 50082-1, EN 61000-3-2, EN 61000-3-3, EN 61000-6-1
Wi-Fi	No
Networking standards	IEEE 802.1Q, IEEE 802.1af, IEEE 802.1p
Ethernet LAN interface type	Fast Ethernet
Supported network protocols	DHCP, TFTP, CDP
Lines quantity	24 lines
Phonebook capacity	- entries
Number of VoIP accounts	-
Voice codecs	G.711a, G.729A, G.729B, G.729ab
Volume control	Digital
Display resolution	192 x 64 pixels
Display number of lines	3 lines
Display number of colors	Monochrome
Storage temperature (T-T)	-10 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Safety	(UL) 60950, (CSA) C22.2 No. 60950, EN 60950, IEC 60950, AS/NZS60950, TS 001
Number of handles included	1 pc(s)

Weight and Dimensions

Depth	229 mm
Width	203 mm
Height	178 mm
Weight	1360 g