Cisco 7941 - Managing Multiple Calls

To Connect Your Phone
• Connect the Ethernet cable from your network wall jack to the port labeled “10/100 SW” on
the back of phone (4).
• Connect the power cable to the round power port on the back of phone (1) and plug the cord
into the power outlet on the wall (3).
To Connect a PC to Your Phone
• Connect the Ethernet cable from the port labeled “10/100 PC” on the back of phone (5) to the
Ethernet port on your PC or laptop. This will allow your PC to access the same network as
the IP phone.
FeatureTel Cisco 7941/7961 IP Phone User Guide Page 4