Cisco 7941G - Unified IP Phone VoIP User Manual

7-5
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE for Cisco Unified Communications Manager 6.1
OL-14620-01
Chapter 7 Viewing Model Information, Status, and Statistics on the Cisco Unified IP Phone
Status Menu
Ta b l e 7-2 Status Messages on the Cisco Unified IP Phone
Message Description Possible Explanation and Action
BootP server used The phone obtained its IP
address from a BootP server
rather than a DHCP server.
None. This message is informational only.
CFG file not found The name-based and default
configuration file was not
found on the TFTP Server.
The configuration file for a phone is created
when the phone is added to the Cisco
Unified
Communications Manager database.
If the phone has not been added to the Cisco
Unified
Communications Manager database,
the TFTP server generates a
CFG File Not
Found
response.
• Phone is not registered with Cisco
Unified
Communications Manager.
You must manually add the phone to
Cisco Unified
Communications Manager
if you are not allowing phones to
auto-register. See the
“Adding Phones
with Cisco Unified Communications
Manager Administration” section on
page 2-17 for details.
• If you are using DHCP, verify that the
DHCP server is pointing to the correct
TFTP server.
• If you are using static IP addresses, check
configuration of the TFTP server. See the
“Network Configuration Menu” section
on page 4-7 for details on assigning a
TFTP server.
CFG TFTP Size Error The configuration file is too
large for file system on the
phone.
Power cycle the phone.

Cisco 7941G - Unified IP Phone VoIP Specifications

General

Brand	Cisco
Model	7941G - Unified IP Phone VoIP
Category	IP Phone
Language	English