Cisco 7941G - Unified IP Phone VoIP User Manual

2-15
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE for Cisco Unified Communications Manager 6.1
OL-14620-01
Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
Adding Phones to the Cisco Unified Communications Manager Database
Adding Phones with Auto-Registration
By enabling auto-registration before you begin installing phones, you can:
• Add phones without first gathering MAC addresses from the phones.
• Automatically add a Cisco Unified IP Phone to the Cisco Unified
Communications Manager database when you physically connect the phone
to your IP telephony network. During auto-registration, Cisco
Unified
Communications Manager assigns the next available sequential directory
number to the phone.
• Quickly enter phones into the Cisco Unified Communications Manager
database and modify any settings, such as the directory numbers, from
Cisco
Unified Communications Manager.
• Move auto-registered phones to new locations and assign them to different
device pools without affecting their directory numbers.
Using the Cisco
Unified
Communications
Manager
Administration
Yes Requires phones to be added
individually
Using BAT Yes • Can add groups of same model of
phone.
• Can schedule when phones are
added to the
Cisco
Unified Communications
Manager database.
Table 2-5 Methods for Adding Phones to the Cisco Unified
Communications Manager Database (continued)
Method
Requires MAC
Address? Notes

Cisco 7941G - Unified IP Phone VoIP Specifications

General

Brand	Cisco
Model	7941G - Unified IP Phone VoIP
Category	IP Phone
Language	English