Cisco 7942G Phone Guide

Basic Call Handling
Cisco Unified IP Phone 7962G and 7942G Phone Guide for Cisco Unified Communications Manager 6.1(3) (SCCP and SIP)
• Join—Allows you to create a standard (ad hoc) conference by combining existing calls. Use the
Join softkey or button. Join is available on SCCP phones only.
• cBarge—Allows you to create a standard (ad hoc) conference by adding yourself to a call on a
shared line. Press a line button or use the cBarge softkey or button. cBarge is only available on
phones that use shared lines.
• Meet-Me—Allows you to create or join a conference by calling a conference number. Use the
MeetMe softkey or button.
Using Conference
Conference allows you to call each participant. Conference is available on most phones.
If you want to... Then...
Create a conference 1. From a connected call, press Confrn or Conference. (You may
need to press the more softkey to see Confrn.)
2. Enter the participant’s phone number.
3. Wait for the call to connect.
4. Press Confrn or Conference again to add the participant to your
call.
5. Repeat to add additional participants.
Add new participants to an
existing conference
Repeat the steps listed above.
Your system administrator determines whether non-initiators of a
conference can add or remove participants.
See a list of participants or
remove participants
See Viewing or Removing Conference Participants, page 32.

Cisco 7942G Specifications

General

Lines	2
Audio Codec Support	G.711, G.729a, G.729ab, G.722
Network Protocols	SIP, SCCP
Ethernet Ports	2 x 10/100
Power Options	PoE 802.3af, Optional Power Cube
Speakerphone	Yes
Headset Port	Yes
Weight	3.5 lbs