Cisco 8861 - Page 330

DescriptionParameter
Interval, in seconds, to allow a reconnect without a
log in after the client disconnects from the server.
After this interval, the client needs to reauthenticate.
Default: 30
Retry Intvl
XML Service
DescriptionParameter
Name of the XML Directory. Displays on the user’s
phone as a directory choice
Default: Blank
XML Directory Service Name
URL where the XML Directory is located.
Default: Blank
XML Directory Service URL
Name of the XML application. Displays on the user’s
phone as a web application choice.
XML Application Service Name
URL where the XML application is located.XML Application Service URL
XML service username for authentication purposes
Default: Blank
XML User Name
XML service password for authentication purposes
Default: Blank
XML Password
Enables or disables Cisco XML EXE authentication.
Default: No
CISCO XML EXE Enable
Specifies the authentication mode for Cisco XML
EXE. The available options are:
• Trusted—No authentication is performed (local
user password is set or not).
• Local Credential—Authentication is based on
digest authentication using the local user
password, if the local user password is set. If not
set, then no authentication is performed.
• Remote Credential—Authentication is based on
digest authentication using the remote
username/password as set in the XML
application on the web page (to access an XML
application server).
Default: Trusted
CISCO XML EXE Auth Mode
Cisco IP Phone 8800 Series Multiplatform Phones Administration Guide
314
Cisco IP Phone Troubleshooting
XML Service