Name: Cisco 8865
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Step 5 Press the phone firmly into the wall bracket and slide the phone down. The tabs in the bracket click into

position.

Step 6 Proceed to Adjust the Handset Rest, on page 505.

Remove the Phone from the Non-Lockable Wall Mount

The wall bracket has two tabs that lock the kit together. Use the following illustration to locate the tabs.

Figure 15: Tab Location

Before you begin

Obtain two Phillips head screwdrivers or other similar devices that have a diameter of 5 millimeters or 3/16ths

of an inch.

Procedure

Step 1 Insert a screw driver or other device into the left and right holes in the phone mounting plate. Insert to a depth

of about 3/4 of an inch or 2 centimeters.

Step 2 Press firmly inwards to disengage the tabs.

Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later

498

Cisco IP Phone Accessories

Remove the Phone from the Non-Lockable Wall Mount

Other manuals for Cisco 8865

Questions and Answers:

Need help?

Do you have a question about the Cisco 8865 and is the answer not in the manual?

General