2-21
Cisco Integrated Services Router Hardware Installation Guide
Chapter 2 Installing the Router
Installing the Cisco 810 ISR
Items Shipped with your Router
Unpack the box and verify that all items listed on the invoice were shipped with the Cisco 819 ISR.
The following items are shipped with your router:
• AC power supply (default)
• AC power supply cable (default)
• Cisco Configuration Professional (Cisco CP) CD
• DC power supply (optional)
• Power cord retention lock (available in Cisco 819HGW, Cisco 819HWD, Cisco 819HG-4G, and
Cisco 819G-4G ISRs only)
• Power switch lock (available in Cisco 819HGW, Cisco 819HWD, and Cisco 819HG-4G ISRs only)
• RJ-45-to-DB-9 console cable.
• Straight-through RJ-45 Ethernet cable
• Two cellular multiband swivel mount dipole antennas
• Three WiFi antennas for Cisco 819HGW and Cisco 819HWD ISRs
Note AC or DC Power supply is included based on the your order.
Additional Items
The following items are not shipped with the router but are required for installation:
• ESD-preventive cord and wrist strap.
• Screws for mounting the router on a wall.
• Two number-10 wood screws (round- or pan-head) with number-10 washers or two number-10
washer-head screws, for mounting on a wall stud. The screws must be long enough to penetrate at
least 3/4 inch (20 mm) into the supporting wood or metal wall stud.
• Two number-10 wall anchors with washers, for mounting the router on a hollow wall.
• Wire crimper for chassis grounding.
• Wire for connecting the chassis to an earth ground.
• AWG 14 (2 mm2) or larger wire for NEC-compliant chassis grounding.
• AWG 18 (1 mm2) or larger wire for EN/IEC 60950–compliant chassis grounding.
• Ring terminal with an inner diameter of 1/4 inch. (5 to 7 mm) for NEC-compliant chassis grounding.
• Ethernet cables for connecting to the Fast Ethernet (FE) WAN and LAN ports.
Connections
Obtain a broadband or Ethernet connection from your service provider.
Ethernet Devices
Identify the Ethernet devices that you will connect to the router: hub, servers, and workstations or PCs.
Ensure that each device has a network interface card (NIC) for connecting to Ethernet ports.
To Next Page
Loading...
Need help?
General
