EasyManuals Logo

Cisco 890 Series User Manual

Cisco 890 Series
292 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #218 background imageLoading...
Page #218 background image
3-10
Cisco Integrated Services Router Hardware Installation Guide
Chapter 3 Connecting the Router
Cisco 860, 880, 890 Series
Warning
Never install telephone jacks in wet locations unless the jack is specifically designed for wet
locations.
Statement 1036
Warning
Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
Statement 1037
Warning
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote
risk of electric shock from lightning.
Statement 1038
Warning
To report a gas leak, do not use a telephone in the vicinity of the leak.
Statement 1039
Warning
Before opening the unit, disconnect the telephone-network cables to avoid contact with
telephone-network voltages.
Statement 1041
Warning
This equipment contains a ring signal generator (ringer), which is a source of hazardous voltage. Do
not touch the RJ-11 (phone) port wires (conductors), the conductors of a cable connected to the RJ-11
port, or the associated circuit-board when the ringer is active. The ringer is activated by an incoming
call.
Statement 1042
Warning
Do not locate the antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, because they may cause serious injury or death. For
proper installation and grounding of the antenna, please refer to national and local codes (for
example, U.S.:NFPA 70, National Electrical Code, Article 810, Canada: Canadian Electrical Code,
Section 54).
Statement 1052
Warning
No user-serviceable parts inside. Do not open.
Statement 1073
Warning
Installation of the equipment must comply with local and national electrical codes.
Statement 1074
Preparing to Connect the Router
Before you connect the router to the devices, install the router according to the instructions in “Installing
the Cisco 860, 880, 890 ISR” section on page 2-38.

Table of Contents

Other manuals for Cisco 890 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 890 Series and is the answer not in the manual?

Cisco 890 Series Specifications

General IconGeneral
Product TypeRouter
Form FactorDesktop
USB Ports1 x USB 2.0
FirewallYes
VPN SupportYes
RAM256 MB
Wireless802.11n
Operating Temperature32°F to 104°F (0°C to 40°C)
Operating Humidity10 to 85% non-condensing
Connectivity TechnologyWired
Data Link ProtocolEthernet, Fast Ethernet, Gigabit Ethernet
Network / Transport ProtocolTCP/IP
Routing ProtocolOSPF, BGP, RIP-1, RIP-2, EIGRP, HSRP, VRRP
Remote Management ProtocolSNMP, Telnet, HTTP, HTTPS, SSH
FeaturesVPN support, firewall protection, Quality of Service (QoS), VLAN support
Encryption AlgorithmAES, 3DES, DES

Related product manuals