EasyManuals Logo

Cisco 8961 Setup Guide

Cisco 8961
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
CHAPTER
5-1
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 8.0 (SIP)
OL-20862-01
5
Setting Up the Cisco Unified Video Camera
The Cisco Unified IP Phone 9951 and 9971 supports the add-on accessory Cisco Unified Video Camera.
The Cisco Unified Video Camera connects to your Cisco Unified IP Phone and allows you to make a
point-to-point video call with another Cisco Unified IP Phone with a Cisco Unified Video Camera
attached. If a phone does not have a Cisco Unified Video Camera attached, it can only receive one-way
video.
This chapter contains the following information:
Configuring the Cisco Unified Video Camera, page 5-1
Attaching the Cisco Unified Video Camera, page 5-2
Adjusting the Camera Settings, page 5-2
Post-Installation Steps, page 5-4
Using the Cisco Unified Video Camera, page 5-4
Configuring the Cisco Unified Video Camera
To configure the Cisco Unified Video Camera, you must perform the following configuration steps in
Cisco Unified Communications Manager administration:
Note The parameters described in the following procedure can be enabled on either the Phone Configuration
window (Device > Phone), the Enterprise Phone Configuration window (System > Enterprise Phone
Configuration), or the Common Phone Profile window (Device > Device Settings > Common Phone
Profile). Be sure to also check the corresponding Override Common Settings parameter in the
configuration window. The Phone Configuration window is referenced below for purposes of the
procedure description.
For more information about parameters that can be configured in any of these three configuration
windows, see the “Configuring Product Specific Configuration Parameters” section on page 8-20.
Procedure
Step 1 In the phone configuration window (Device > Phone) of the phone to which you are adding the Cisco
Unified Video Camera, enable the Cisco Camera parameter. This field is located in the Product Specific
Configuration layout portion of the window.

Other manuals for Cisco 8961

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 8961 and is the answer not in the manual?

Cisco 8961 Specifications

General IconGeneral
Resolution640 x 480 pixels
Display5-inch TFT color display
Ethernet10/100/1000 Mbps
PowerIEEE 802.3af Power over Ethernet (PoE) Class 3
ConnectivityTwo-port Gigabit Ethernet switch
Buttons4 softkeys
USB PortYes, supports USB 2.0
Headset JackYes, dedicated headset port
SpeakerphoneFull-duplex speakerphone
Codec SupportG.711, G.722, G.729, iLBC
Security802.1X authentication, TLS, SRTP, HTTPS

Related product manuals