Cisco A9K-SIP-700 Configuration Guide

PurposeCommand or Action
address-family { ipv4 | ipv6 } multicast topology topo-name
Step 5
•
Enters isis address-family interface
configuration submode.
Example:
RP/0/RSP0/CPU0:router(config-isis-if)# address-family
ipv4 multicast topology green
•
Places the interface instance into a
topology.
—
Repeat Step 4, on page 294 and Step 5, on page 295 until you have
specified all the interface instances and associated topologies you
want to configure in your network.
Step 6
commit
Step 7
Configuring a Routing Policy
For more information about creating a routing policy and about the set rpf-topology command, see
Cisco ASR 9000 Series Aggregation Services Router Routing Command Reference.
SUMMARY STEPS
1.
configure
2.
route-policy policy-name
3.
end-policy
4.
commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Defines a routing policy and enters routing policy
configuration submode.
route-policy policy-name
Example:
RP/0/RSP0/CPU0:router(config)# route-policy mt1
Step 2
For detailed information about the use of the
set-rpf-topology and other routing configuration
commands, see Cisco ASR 9000 Series Aggregation
Services Router Routing Command Reference.
RP/0/RSP0/CPU0:router(config-rpl)# if destination in
225.0.0.1, 225.0.0.11 then
RP/0/RSP0/CPU0:router(config-rpl-if)# if source in
(10.10.10.10) then
RP/0/RSP0/CPU0:router(config-rpl-if-2)# set
rpf-topology ipv4 multicast topology greentable
RP/0/RSP0/CPU0:router(config-rpl-if-2)# else
RP/0/RSP0/CPU0:router(config-rpl-if-else-2)# set
rpf-topology ipv4 multicast topology bluetable
RP/0/RSP0/CPU0:router(config-rpl-if-else-2)# endif
RP/0/RSP0/CPU0:router(config-rpl-if)# endif
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
OL-30423-03 295
Implementing IS-IS
Configuring Multitopology Routing

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English