Global-Inbound
The global-inbound attach point for RIP allows you to filter or update inbound RIP routes that match a route
policy.
The following example shows how to filter the inbound RIP routes that match the route policy named rip-in:
router rip
route-policy rip-in in
Global-Outbound
The global-outbound attach point for RIP allows you to filter or update outbound RIP routes that match a
route-policy.
The following example shows how to filter the outbound RIP routes that match the route policy named rip-out:
router rip
route-policy rip-out out
Interface-Inbound
The interface-inbound attach point allows you to filter or update inbound RIP routes that match a route policy
for a specific interface.
The following example shows how to filter inbound RIP routes that match the route policy for interface
0/1/0/1:
router rip
interface GigabitEthernet0/1/0/1
route-policy rip-in in
Interface-Outbound
The interface-outbound attach point allows you to filter or update outbound RIP routes that match a route
policy for a specific interface.
The following example shows how to filter outbound RIP routes that match the route policy for interface
0/2/0/1:
router rip
interface GigabitEthernet0/2/0/1
route-policy rip-out out
RIP Attributes and Operators
This table summarizes the RIP attributes and operators per attach points.
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
OL-30423-03 529
Implementing Routing Policy
Attach Points
To Next Page
Loading...
Need help?
General
