PurposeCommand or Action
•
Low-Set to monitor route convergence for
low priority routes
Disables the monitoring of route convergence for
specified priority.
disable
Example:
RP/0/RSP0/CPU0:router(config-rcmd-proto-prio)#disable
Step 10
Enables leaf network monitoring. Specify a
maximum number of leaf networks to be
leaf-network number
Example:
RP/0/RSP0/CPU0:router(config-rcmd-proto-prio)#leaf-network
100
Step 11
monitored. Range for maximum number is
10-100.
Specifies threshold value for convergence in
milliseconds. Select a threshold value from the
range. Range is 0-4294967295 milliseconds
threshold value
Example:
RP/0/RSP0/CPU0:router(config-rcmd-proto-prio)#threshold
1000
Step 12
Sets the absolute directory path for storing
diagnostic reports.
storage-location
Example:
RP/0/RSP0/CPU0:router(config-rcmd)#storage-location
RP/0/RSP0/CPU0:router(config-rcmd-store)#
Step 13
Specifies the absolute directory path for storing
diagnostic reports. Set a directory-path-name.
Example: /disk0:/rcmd/ or <tftp-location>/rcmd/
diagnostics directory-path-name
Example:
RP/0/RSP0/CPU0:router(config-rcmd-store)#diagnostics
/disk0:/rcmd
Step 14
Specify a maximum size for the diagnostics
directory. Set the size in %. Range is 5%-80%.
diagnostics-size
Example:
RP/0/RSP0/CPU0:router(config-rcmd-store)# diagnostics-size
8
Step 15
Specifies the absolute directory path for storing
reports. Set a directory-path-name. Example:
/disk0:/rcmd/ or <tftp-location>/rcmd/
reports directory-path-name
Example:
RP/0/RSP0/CPU0:router(config-rcmd-store)#reports
/disck0:/rcmd
Step 16
Specify a maximum size for the reports directory.
Set the size in %. Range is 5%-80%.
reports-size
Example:
RP/0/RSP0/CPU0:router(config-rcmd-store)#reports-size 8
Step 17
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
570 OL-30423-03
Implementing RCMD
Configuring Route Convergence Monitoring and Diagnostics
To Next Page
Loading...
Need help?
General
