Cisco AIR-AP1572IC - Page 102

E-2
Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide
OL-32138-01
Appendix E Access Point Pinouts
Table E-3 describes the pin signals for the power injector input connector (To Switch).
Table E-4 describes the RJ-45 pin signals for the power injector output connector (To AP). The Pinouts
given in this table are applicable to AIR-POWERINJ1500. Not all PoE power sources follow these
pinouts.
7 Ethernet signal pair (1000BASE-T) and DC return
8
Shield Chassis ground
Table E-2 Access Point PoE-In Ethernet Connector Pinouts for AIR-POWERINJ1500
Pin Number Signal Name
Table E-3 Power Injector Input Connector (To Switch) Pinouts
Pin Number Signal Name
1 Ethernet signal pair (10/100/1000BASE-T)
2
3 Ethernet signal pair 10/100/1000BASE-T)
6
4 Ethernet signal pair (1000BASE-T)
5
7 Ethernet signal pair (1000BASE-T)
8
Shield Chassis ground
Table E-4 Power Injector AIR-POWERINJ1500 Output Connector (To AP) Pinouts
Pin Number Signal Name
1 Ethernet signal pair (10/100/1000BASE-T) and DC return
2
3 Ethernet signal pair (10/100/1000BASE-T) and DC (+)
6
4 Ethernet signal pair (1000BASE-T) and DC (+)
5
7 Ethernet signal pair (1000BASE-T) and DC return
8
Shield Chassis ground