Cisco Aironet 1200 Series - Network Example with Lightweight Access Points

1-12
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-8370-04
Chapter 1 Overview
Network Example with Lightweight Access Points
Network Example with Lightweight Access Points
The lightweight access points support Layer 3 network operation. Lightweight access points and
controllers in Layer 3 configurations use IP addresses and UDP packets, which can be routed through
large networks. Layer 3 operation is scalable and recommended by Cisco.
This section illustrates a typical wireless network configuration containing lightweight access points and
a
Cisco Wireless LAN Controller (see Figure 1-9).
Figure 1-9 Typical Lightweight Access Point Network Configuration Example
158085
LWAPP
LWAPP