Cisco Aironet 1200 Series - Radio Configuration

4-10
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-8370-04
Chapter 4 Upgrading the 2.4-GHz Radio
Attaching the Compliance Labels
Placing the Labels
The 802.11g radio upgrade kit ships with the following labels for the 1100 and 1200 series access points:
• 1100 series access point upgrade label (AIR-1121G-x-K9 UPGRADE)—not used on the 1200 series
access point.
• 1200 series product compliance label (AIR-AP1231G-x-K9)
• 1200 series radio compliance label (AIR-MP21G-x-K9)
Table 4-1
shows where to place the labels on your 1200 series access point, based on the model you are
upgrading. Follow these steps to place the labels correctly:
Step 1 Check the product compliance label to identify the model number of your 1200 series access point.
Step 2 Use the matrix in Table 4-1 to decide which labels to use and where to place them on the access point.
Step 3 Discard any labels that you did not use.
The radio card installation is now complete.
Ta b l e 4-1
1200 Series
Model
AIR-MP21G-x-K9
Radio Compliance Label
AIR-AP1231G-x-K9 Product
Compliance Label
AIR-AP1200 Place over existing AIR-MP20B-x-K9
r
adio compliance label or location 2 if no
label exists.
—
AIR-AP1210
AIR-AP1220A
AIR-AP1230A
AIR-AP1220B — Place over existing AIR-AP12xx-x-K9
p
roduct compliance label.
AIR-AP1230B