Cisco Aironet 1200 Series - Installing a 2.4-Ghz Radio

4-7
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-8370-04
Chapter 4 Upgrading the 2.4-GHz Radio
Installing a 2.4-GHz Radio
Installing a 2.4-GHz Radio
To install a new 2.4-GHz radio card into the access point, follow these steps:
Caution The internal access point components and the 2.4-GHz radio can be damaged by ESD from improper
handling.
Step 1 Carefully remove the Cisco Aironet 2.4-GHz radio card from its anti-static bag.
Step 2 Grasp the radio card only on the edges, being careful not to touch components on the board or the gold
connector pins.
Step 3 Connect the black antenna wire connector to the radio card antenna connector marked by the black label
(see Figure 4-4).
Caution To avoid damaging the antenna wire assemblies, handle them by their connectors.
Figure 4-4 Antenna Connector Labels and Mini-PCI Connector
Step 4 Connect the white antenna wire connector to the radio card antenna connector marked by the white label
(see Figure 4-4).
MAIN AUX
74251
3
2
1
1 Antenna connector (black wire) 3 Mini-PCI connector
2 Antenna connector (white wire)