4-6
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-8370-04
Chapter 4 Upgrading the 2.4-GHz Radio
Removing a 2.4-GHz Radio
Step 2 Remove the 2.4-GHz radio card from the mini-PCI connector by performing the following operations:
a. Push the card-retaining clips (on each side of card) away from the card (see Figure 4-3). When
released, the radio card springs up (see Figure 4-4).
Figure 4-3 Location of Retaining Clips on 2.4-GHz Radio Card
b. Grasp the radio card only on the edges, being careful not to touch components on the board or the
gold connector pins.
c. Remove the 2.4-GHz card from the mini-PCI connector.
Step 3 Place the removed 2.4GHz radio card into an anti-static bag.
For instructions on installing a new radio card, go to the “
Installing a 2.4-GHz Radio” section.
1 Card-retaining clips
To Next Page
Loading...
