Cisco Aironet 1240AG Series - Access Point Specifications; Physical and Electrical Specifications

Draft 1A - CISCO CONFIDENTIAL
C-1
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
OL-7293-01
APPENDIX
C
Access Point Specifications
Table C-1 lists the technical specifications for the Cisco Aironet 1240AG Series Access Point.
Table C-1 Access Point Specifications
Category 802.11G Radio Specifications 802.11A Radio Specifications
Size 6.6 in. W x 8.5 in. D x 1.1 in. H
16.8 cm W x 21.6 cm D x 2.8 cm H
Indicators Three indicators on the 2.4 Ghz end panel: Ethernet traffic, status, and radio traffic.
Connectors 2.4 GHz end panel (left to right)
Left RP-TNC antenna connector; RJ-45 connector for serial console port connections; RJ-45
connector for 10BASE-T or 100BASE-T Ethernet connections; power connector (for plug-in
48VDC AC power module); right RP-TNC antenna connector.
5-GHz end panel (left to right)
Left RP-TNC antenna connector; right RP-TNC antenna connector.
Input Voltage 48 VDC (nominal)
Input Power TBD W (typical)
12 W (maximum)
Operating Temperature Base unit:
–4 to 122
o
F (–20 to 50
o
C)
1240AG series power module:
32 to 104
o
F (0 to 40
o
C)
Weight Without mounting hardware:
2 lbs (0.9 kg)
Power Output 100 mW (20dBm)
50 mW (17 dBm)
25 mW (14 dBm)
10 mW (11 dBm)
5 mW (8 dBm)
3 mW (5 dBm)
1 mW (2 dBm)
0.5 mW (-1 dBm)
(Depending on the regulatory domain in which the access point is
installed)
50 mW (17 dBm)
25 mW (14 dBm)
10 mW (11 dBm)
5 mW (8 dBm)
3 mW (5 dBm)
1 mW (2 dBm)
0.5 mW (-1 dBm)
(Depending on the regulatory
domain in which the access point
is installed)