Cisco Aironet 1240AG Series - Status Checks and Basic Issues

Draft 1A - CISCO CONFIDENTIAL
6-2
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
OL-7293-01
Chapter 6 Troubleshooting
Checking the Access Point LEDs
Checking the Access Point LEDs
If your access point is not working properly, check the Status, Ethernet, and Radio LEDs on the 2.4 GHz
end of the unit. You can use the LED indications to quickly assess the unit’s status. Figure 6-1 shows the
access point LEDs (for additional information refer to the Event Log using the access point browser
interface).
Figure 6-1 Access Point LEDs
1 Status LED 3 Radio LED
2 Ethernet LED