Cisco Aironet 1240AG Series - Network Configuration Examples

Draft 1A - CISCO CONFIDENTIAL
1-8
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
OL-7293-01
Chapter 1 Overview
Network Configuration Examples
Network Configuration Examples
This section describes the access point’s role in three common wireless network configurations. The
access point’s default configuration is as a root unit connected to a wired LAN or as the central unit in
an all-wireless network. The repeater role requires a specific configuration.
Root Unit on a Wired LAN
An access point connected directly to a wired LAN provides a connection point for wireless users. If
more than one access point is connected to the LAN, users can roam from one area of a facility to another
without losing their connection to the network. Figure 1-6 shows access points acting as root units on a
wired LAN.
Figure 1-6 Access Points as Root Units on a Wired LAN --- TBD ----
Access Point
(Root Unit)
Access Point
(Root Unit)
121672
Wired LAN