2-2
Cisco Aironet 1530 Series Outdoor Access Point Hardware Installation Guide
OL-30864-01
Chapter 2 Installing the Access Point
Unpacking the Access Point
Unpacking the Access Point
To unpack the access point, follow these steps:
Step 1 Open the shipping container and carefully remove the contents.
Step 2 Return all packing materials to the shipping container, and save it.
Step 3 Ensure that all items listed in “Package Contents” are included in the shipment. If any item is damaged
or missing, notify your authorized Cisco sales representative.
Package Contents
Each access point package contains the following items:
• One 1530 series access point
• Two-pin DC power connector
• Ground lug and screws with lock washers
• Plastic cable gland and rubber seal
• Weatherization tape and anti-corrosion sealant
• Cisco product documentation and pointer card
Tools and Hardware
The tools and hardware used to install the 1532 access point are described in:
• Optional Tools and Hardware, page 2-2
• Optional Tools and Hardware That You Supply, page 2-3
• Warnings, page 2-3
• Warnings, page 2-3
Optional Tools and Hardware
Depending on what you ordered, the following optional equipment may be part of your shipment:
• External antennas, depending on which ones you purchased (see “Antenna Configurations” section
on page 2-29 for more information).
• Wall/Pole mount bracket, available as an option or a spare (AIR-ACC1530-PMK1[=])
• Wall/Pole mount bracket with tilt mechanism, spare only (AIR-ACC1530-PMK2=)
• AP cover / Solar Shield for 1532, spare only (AIR-ACC1530-CVR=)
• AC/DC power adapter, spare only (AIR-PWRADPT-1530=)
• Spare Parts kit containing extra cable glands, power connector, ground lug, etc.
(AIR-ACC1530-KIT1=)
To Next Page
Loading...
