2-20
Cisco Aironet 1530 Series Outdoor Access Point Hardware Installation Guide
OL-30864-01
Chapter 2 Installing the Access Point
Mounting the Access Point
Step 6 Using the long bolt and the hardware supplied with the pivoting bracket, bolt the AP and its mounted
bracket, on to the bracket mounted on the wall (see Figure 2-11 for an exploded view of this assembly).
Step 7 Pivot the AP to your desired position, and then tighten the bolts (using a 13 mm wrench).
Step 8 Continue with Grounding the Access Point, page 2-40.
Pole Mounting the Access Point with the Pivoting Mounting Kit
The optional pivoting mounting kit contains a mounting bracket for wall mounting or pole mounting,
along with a clamp for pole mounting.This kit can be used to install the access point on a pole, mast or
streetlight. It supports metal, wood or fiberglass poles from 2 to 8 inches in diameter.
Figure 2-10 Pivoting Mounting Kit with Pole Mount Clamp
1 Mounting holes for the access point 2 Slots for band clamps (band clamps are
provided but not shown in this figure. See
Figure 2-12).
3 Pole mount clamp. It can fit poles of range up
to 3 in. (76mm)
To Next Page
Loading...
