2-24
Cisco Aironet 1530 Series Outdoor Access Point Hardware Installation Guide
OL-30864-01
Chapter 2 Installing the Access Point
Mounting the Access Point
Step 1 Mount the pivot bracket to a wall or a pole as shown in the previous procedures.
Step 2 Using four M6 x 12 mm bolts mount the horizontal adapter plate to the bracket mount plate.
Do not mount the pivot bracket mounting plate directly to the access point.
Step 3 Using the remaining four M6 x 12 mm bolts, mount the other side of the horizontal mounting plate to
the AP. See Figure 2-14 for the exploded view.
Step 4 Using a 10 mm wrench or socket, tighten all M6 bolts to 40 lbf-in (4.5 Nm).
Step 5 Position the access point as needed and tighten the mount kit bolts using a 13 mm wrench or socket.
Drill bit for wall anchors No
Electric drill and standard screwdriver No
#6 AWG ground wire No
Shielded outdoor-rated Ethernet (CAT5e or better) cable No
Grounding block No
Grounding rod No
13-mm box-end wrench or socket set No
10-mm box-end wrench No
Materials Required In Kit
To Next Page
Loading...
