Installing the AC Power Supply into Cisco ASR 1001 Router
The Cisco ASR 1001 Router has two AC power supplies at the rear of the chassis. The input receptacle is an
IEC60320 C14 type of filtered AC Inlet. The current rating on the connector is 10 A. The following figure
shows the ASR 1001 Router AC power supply.
Figure 74: Cisco ASR 1001 Router AC Power Supply
To connect an AC-input power supply to the Cisco ASR 1001 Router, follow these steps:
SUMMARY STEPS
1. There are two power supplies installed. At the rear of the chassis, check whether the power switch on the
chassis is in the Standby position.
2. Turn off the circuit breaker to the power supply.
3. For easier installation, plug the power cable into the inlet on power supply slot 1 first.
4. Insert the power supply cable into the power supply in slot 0 on the left.
5. Ensure that the AC power cords are positioned, as shown in the following figure.
6. Plug the AC power supply cables into the AC power source.
7. Turn on the AC breaker.
8. Turn the Standby switch to On (|) on the chassis.
9. The power supply LEDs illuminate green.
DETAILED STEPS
Step 1 There are two power supplies installed. At the rear of the chassis, check whether the power switch on the chassis is in
the Standby position.
Do not install the Cisco ASR 1001 Router power supplies without the top cover on the Cisco ASR 1001 chassis.
Warning
The following figure shows the Cisco ASR 1001 Router AC power supply standby switch.
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
109
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Installing the AC Power Supply into Cisco ASR 1001 Router
To Next Page
Loading...
Need help?
General
