Veritas Cluster Installation and Management
▄ Cisco ASR 5000 Series External Storage Server Installation and Administration Guide
Installing Hardware
To install the hardware components required for the installation of L-ESS cluster:
Step 1 Rack the Sun Netra T5220 servers and storage array and connect power to each of them.
Step 2 Connect Ethernet port 0 on each server to an Ethernet switch.
Step 3 Connect Ethernet port 1 on server 1 to Ethernet port 1 on server 2 with a cross-over cable.
Step 4 Connect Ethernet port 2 on server 1 to Ethernet port 2 on server 2 with a cross-over cable.
Step 5 Connect a terminal (pc with terminal emulation such as HyperTerm) to the console port. Settings for the console are
9600 8, 1, N. Console cable and DB9 to RJ45 adapter are included with each server.
Step 6 Connect one SCSI cable from CH 0 on the Storage Array to Single Bus Conf as shown in the following figure. DO
NOT make any connections to Sun Servers at this time.
Step 7 Connect the Ethernet ports on each array controller to an Ethernet switch.
Step 8 Insert install DVD into DVD-ROM in the first Sun server. Make sure the server is NOT cabled to the storage array.
Step 9 Power on the server.
Step 10 Wait for the ok prompt on the console.
Step 11 To boot the machine from the DVD, enter:
ok> boot cdrom install
Step 12 The install will run for some time. After the image has been loaded, you will be prompted for the host information
shown below:
# Please enter the desired hostname for this machine.
# Please enter the desired IP address for bge0.
# Please enter the netmask for bge0.
# Please enter the default router for bge0.
Step 13 After entering hostname, IP address, netmask, and default router information, you must confirm the inputs.
Please verify your configuration information:
hostname:
To Next Page
Loading...
Need help?
General
