L-ESS Installation and Configuration
Installing L-ESS Application in Cluster Mode ▀
Cisco ASR 5000 Series External Storage Server Installation and Administration Guide ▄
Type the password used to log on to chassis.
Important: This parameter is applicable only if the source or destination is
at remote location.
The above mentioned parameters are stored in a database. These parameters can be added, removed or modified through the config
utility. If you would like to change any of the existing configuration, or set additional parameters, see the L-ESS Server
Configuration section in this guide.
The ess process when started by PSMON will take the configuration from this file. If you would like to change any of
the existing configuration, or set additional parameters, see the L-ESS Server Configuration section in this guide.
Step 6 After completion of L-ESS installation on node1, execute the L-ESS installation script on node2.
Step 7 Type (y)es to continue the installation. The script displays the configuration settings for node1. If you want to make
changes to the existing configuration, modify the configuration as needed.
Step 8 If you do not want to make any changes to the configurations, type (y)es to continue the installation.
After successful installation of L-ESS, verify the status of the L-ESS cluster resource group by entering the following
command:
For Sun cluster:
scstat
For Veritas cluster:
hastatus
The system displays the status of various cluster nodes, elements and resources. The status of the nodes must be online
as displayed below:
---------------- Cluster Nodes ----------------
Node name Status
--------- -------
Cluster node: clustems2 Online
Cluster node: clustems1 Online
---------------------------------------------------
--------- Cluster Transport Paths ---------
Endpoint Endpoint Status
----------------- ------------------
To Next Page
Loading...
Need help?
General
