EasyManuals Logo
Home>Cisco>Network Router>ASR 900 Series

Cisco ASR 900 Series Release Notes

Cisco ASR 900 Series
310 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #184 background imageLoading...
Page #184 background image
32
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Chapter
Caveats in Cisco IOS XE 3.8S Releases
–
Use Interior Gateway Protocol (IGP) instead of static IP routes.
–
Shut down one of the ECMP paths.
• CSCud38592
Symptom: The router displays an fman_fp crash error and crashes.
Conditions: Occurs when the router is running Remote LFA with a high number of prefixes and
there is an interface flap on the primary path.
Workaround: There is no workaround.
• CSCud38668
Symptom: The OC-3 interface module crashes.
Conditions: Occurs when you issue the show platform software agent iomd 1/0 driver peek
command.
Workaround: There is no workaround.
• CSCud40930
Symptom: Some interfaces within a bridge-domain are unable to send outbound L3 multicast
traffic.
Conditions: Occurs when the bridge-domain contains EFP interfaces, some of which are on a
port-channel. The issue can also occur after a router reload.
Workaround: Issue a shutdown/no shutdown on the BDI interface.
• CSCud42315
Symptom: The OC-3 interface module crashes.
Conditions: Occurs when you apply the forward-alarm ais command on a T1 controller.
Workaround: There is no workaround.
• CSCud43580
Symptom: The router does not apply the bandwidth remaining percent command within a QoS
policy in some instances.
Conditions: The issue can occur occasionally when:
–
There is a large discrepancy in bandwidth remaining values between QoS classes
–
The classes containing the bandwidth remaining statements are oversubscribed at a low rate
or have a low queue-limit.
Workaround: Apply the following workaround:
–
Increase the queue-limit value to 120 kilobytes or above.
–
If the QoS configuration uses WRED, increase the minimum threshold value.
–
Alter the bandwidth remaining values to reduce the ratio between values.
• CSCud44640
Symptom: The router displays a traceback error when there one power supply unit slot is empty.
Conditions: Occurs during boot.
Workaround: There is no workaround.
• CSCud44768
Symptom: Multilink bundles and member links flap when passing traffic.

Table of Contents

Other manuals for Cisco ASR 900 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 900 Series and is the answer not in the manual?

Cisco ASR 900 Series Specifications

General IconGeneral
BrandCisco
ModelASR 900 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals