EasyManuals Logo
Home>Cisco>Network Router>ASR 900 Series

Cisco ASR 900 Series Release Notes

Cisco ASR 900 Series
310 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #185 background imageLoading...
Page #185 background image
33
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Chapter
Caveats in Cisco IOS XE 3.8S Releases
Conditions: Occurs under the following conditions:
You configure more than 210 MLPPP bundles with one member link per bundle or 16 bundles
with 16 member links each.
The line is operating at a 64 or 128 byte line rate
Workaround: There is no workaround.
CSCud49684
Symptom: The router displays an FMAN-FP memory leak error message.
Conditions: Occurs when you configure L3VPN at a high scale.
Workaround: There is no workaround.
CSCud49980
Symptom: The router does not learn remote Connectivity Fault Management (CFM) Maintenance
Endpoint (MEPs).
Conditions: Occurs when you configure CFM MEPs on carrier edge (CE) routers and VPLS on
provider edge (PE) routers.
Workaround: Create an EVC bridge-domain running CFM on the PE router and enable a virtual
forwarding interface (VFI) on the bridge-domain.
CSCud50851
Symptom: The router experiences flapping on REP connections.
Conditions: Occurs when you enable MAC limiting at a high scale and the set of MAC addresses
changes continuously.
Workaround: Disable MAC limiting.
CSCud54092
Symptom: The router displays an error message indicating a crash at
tdl_netsync_clk_src_message_create.
Conditions: The issue can occur when the router is shutting down during a reload
Workaround: There is no workaround.
CSCud55377
Symptom: The router crashes.
Conditions: Occurs when you configure offloaded CFM for xconnect sessions at a high scale.
Workaround: There is no workaround.
CSCud55695
Symptom: When you apply an QoS policy with a port level class-default configuration containing
a shaper value to a serial interface. the router applies the shaper value to the channel-level PIR for
all serial interfaces on the IM.
Conditions: Occurs when you apply QoS policy with a port level class-default configuration
containing a shaper value to a serial interface.
Workaround: Add a dummy class-default level at the top of the policy and apply the shaper as a
child policy of this class.
CSCud58793
Symptom: The FPD version is blank

Table of Contents

Other manuals for Cisco ASR 900 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 900 Series and is the answer not in the manual?

Cisco ASR 900 Series Specifications

General IconGeneral
BrandCisco
ModelASR 900 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals