Cisco ASR 9000 Series Configuring

Configuring Channelized SONET/SDH on the Cisco ASR 9000 Series Router
How to Configure Channelized SONET/SDH
HC-349
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
OL-26061-03
Configuring SDH AU-4
This task explains how to configure an SDH AU-4 stream into a TUG-3 channel mapped to E3s.
Prerequisites
• You should know how to configure the SONET controller as specified in the “How to Configure
Clear Channel SONET Controllers” section of the Configuring Clear Channel SONET Controllers
on the Cisco ASR 9000 Series Router module.
Restrictions
• Channelized SDH is supported on the following SPAs:
– Cisco 1-Port Channelized OC-48/STM-16 SPA
– Cisco 1-Port Channelized OC-3/STM-1 SPA
– Cisco 2-Port Channelized OC-12/DS0 SPA
• In this release, AU-4 paths can only be channelized into TUG-3s.
• The 1-Port Channelized OC-48/STM-16 SPA does not support T1 or E1 channelization.
SUMMARY STEPS
1. configure
2. controller sonet interface-path-id
3. clock source {internal | line}
4. framing sdh
5. au number
6. mode tug3
7. width number
8. tug3 number
9. mode mode
10. root
11. controller name interface-path-id
12. mode mode
13. root
14. controller name instance
15. channel-group number
16. timeslots num1:num2:num3:num4
or
timeslots range1-range2
17. show configuration
18. root
19. interface serial interface-path-id

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model