Cisco ASR 9000 Series Configuring

Configuring Channelized SONET/SDH on the Cisco ASR 9000 Series Router
Configuration Examples for Channelized SONET
HC-358
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
OL-26061-03
mode tug3
tug3 1
mode t3
root
controller t3 0/4/0/0/1/1
mode serial
commit
The following exampe shows SDH AU-4 channelization to TUG-3 and clear channel E3:
configure
controller sonet 0/4/0/0
framing sdh
au 1
width 3
mode tug3
tug3 1
mode e3
root
controller e3 0/4/0/0/1/1
mode serial
commit
Channelized SDH AU-4 to TUG-3, TUG-2, and T1/E1 and NxDS0: Examples
Note Channelization to T1/E1 and NxDS0s is not supported on the 1-Port Channelized OC-48/STM-16 SPA.
The following example shows SDH AU-4 configuration with unframed E1 controllers and serial
interfaces:
configure
controller sonet 0/1/2/0
framing sdh
au 1
width 3
mode tug3
tug3 1
mode c12-e1
!
tug3 2
mode c12-e1
!
tug3 3
mode c12-e1
!
controller E1 0/1/2/0/1/1/1/1
framing unframed
!
controller E1 0/1/2/0/1/1/1/2
framing unframed
!
controller E1 0/1/2/0/1/1/1/3
framing unframed
!
interface Serial0/1/2/0/1/1/1/1:0
encapsulation ppp
multilink
group 1
!
interface Serial0/1/2/0/1/1/1/2:0
encapsulation ppp

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model