Cisco ASR 903 Guide

BGP PIC & RFC3107
▀ Configuration for BGP PIC (with OSPF)
▄ Cisco ASR 903 Router Design and Deployment Guide
118
OL-30526-01
remote-as 100
update-source Loopback10
address-family ipv4 unicast
route-reflector-client
next-hop-self
!
address-family ipv4 labeled-unicast
route-reflector-client
next-hop-self
!
!
neighbor 172.16.22.22
remote-as 100
update-source Loopback10
address-family ipv4 unicast
!
!
!
route-policy DENY
drop
end-policy
!
route-policy PERMIT
if destination in (172.16.11.11/32) then
pass
else
drop
endif
end-policy
!
ASR9k-2 Configuration
!
interface GigabitEthernet0/0/0/16
ipv4 address 10.10.4.2 255.255.255.0
negotiation auto
!
interface GigabitEthernet0/0/0/17
ipv4 address 10.10.7.1 255.255.255.0
negotiation auto
!
interface GigabitEthernet0/0/0/18
ipv4 address 10.10.6.1 255.255.255.0
negotiation auto
!
router ospf 10
router-id 172.16.22.22
area 0
interface GigabitEthernet0/0/0/16
!
!
area 20

Cisco ASR 903 Specifications

General

Form Factor	Modular
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	5% to 95% non-condensing
Redundancy	Yes, redundant power supplies and route processors
Operating System	Cisco IOS XE
Power Supply	AC or DC
Switching Capacity	240 Gbps
Operating Temperature	-40°C to 65°C (-40°F to 149°F)
MTBF	200, 000 hours
Supported Protocols	IPv4, IPv6, MPLS, L2VPN, L3VPN
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, T1/E1