Cisco ASR 903 Guide

Clocking
PTP Configuration ▀
Cisco ASR 903 Router Design and Deployment Guide▄
OL-30526-01
141
Name Tx Mode Role Transport State Sessions
Port Addr
TPSlave unicast slave Lo10 Slave 1
192.168.2.11
Master unicast master Lo11 Master 2 -
SESSION INFORMATION
TPSlave [Lo10] [Sessions 1]
Peer addr Pkts in Pkts out In Errs Out Errs
192.168.2.11 250189 84844 0 0
Master [Lo11] [Sessions 2]
Peer addr Pkts in Pkts out In Errs Out Errs
10.10.2.2 64635 195790 0 0
10.10.4.4 47482 143833 0
ASR903-R1# show network-clocks synchronization
Symbols: En - Enable, Dis - Disable, Adis - Admin Disable
NA - Not Applicable
* - Synchronization source selected
# - Synchronization source force selected
& - Synchronization source manually switched
Automatic selection process : Enable
Equipment Clock : 2048 (EEC-Option1)
Clock Mode : QL-Enable
ESMC : Disabled
SSM Option : 1
T0 : Internal
Hold-off (global) : 300 ms
Wait-to-restore (global) : 30 sec
Tsm Delay : 180 ms
Revertive : No
Nominated Interfaces
Interface SigType Mode/QL Prio QL_IN ESMC Tx ESMC Rx
Internal NA NA/Dis 251 QL-SEC NA NA
*PTP (Dom 0) NA NA/En 10 QL-PRC NA NA

Cisco ASR 903 Specifications

General

Form Factor	Modular
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	5% to 95% non-condensing
Redundancy	Yes, redundant power supplies and route processors
Operating System	Cisco IOS XE
Power Supply	AC or DC
Switching Capacity	240 Gbps
Operating Temperature	-40°C to 65°C (-40°F to 149°F)
MTBF	200, 000 hours
Supported Protocols	IPv4, IPv6, MPLS, L2VPN, L3VPN
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, T1/E1