▄ Cisco ASR 903 Router Design and Deployment Guide
Port0: GigabitEthernet0/2/1 (Monitor: GigabitEthernet0/2/1)
APS-Channel: GigabitEthernet0/2/1
Status: RPL, blocked
Remote R-APS NodeId: 0000.0000.0000, BPR: 0
Port1: GigabitEthernet0/2/0 (Monitor: GigabitEthernet0/2/0)
APS-Channel: GigabitEthernet0/2/0
Status: Non-RPL
Remote R-APS NodeId: 0000.0000.0000, BPR: 0
APS Level: 7
Profile: g8032_profile
WTR interval: 1 minutes
Guard interval: 500 milliseconds
HoldOffTimer: 0 seconds
Revertive mode
ASR903-R2# show ethernet ring g8032 brief
R: Interface is the RPL-link
F: Interface is faulty
B: Interface is blocked
FS: Local forced switch
MS: Local manual switch
RingName Inst NodeType NodeState Port0 Port1
--------------------------------------------------------------------------------
g8032_ring 1 Normal Idle
ASR903-R2# show ethernet ring g8032 port status
Port: GigabitEthernet0/2/0
Ring: g8032_ring
Block vlan list:
Unblock vlan list: 10,1000-2999
REQ/ACK: 6/6
Instance 1 is in Unblocked state
Port: GigabitEthernet0/2/1
Ring: g8032_ring
Block vlan list:
Unblock vlan list: 10,1000-2999
REQ/ACK: 5/5
Instance 1 is in Unblocked state
ASR903-R2# show ethernet ring g8032 status
Ethernet ring g8032_ring instance 1 is Normal Node node in Idle State
Port0: GigabitEthernet0/2/0 (Monitor: GigabitEthernet0/2/0)
APS-Channel: GigabitEthernet0/2/0
Status: Non-RPL
Remote R-APS NodeId: d0c2.8216.29bf, BPR: 0
Port1: GigabitEthernet0/2/1 (Monitor: GigabitEthernet0/2/1)
APS-Channel: GigabitEthernet0/2/1
Status: Non-RPL
Remote R-APS NodeId: 0000.0000.0000, BPR: 0