Cisco ASR 920 series

Install the AC Power Cables
To install the AC power cables in the power supply slots:
Procedure
Step 1 Plug the power supply cord in the power supply module.
Step 2 Insert the power supply cord into the tie [1] and tighten the tie around the power supply cord as shown in [2]
in the figure below.
Figure 57: Attach the AC Power Tie-and-Clip Cord
Activate an AC Power Supply Module
Perform the following procedure to activate an AC power supply:
Installing the Cisco ASR 920 Series Router
62
Installing the Cisco ASR 920 Series Router
Install the AC Power Cables