Cisco Catalyst 2960-X Command Reference

Table 5: show lacp internal Field Descriptions
DescriptionField
State of the specific port. These are the allowed
values:
•
– —Port is in an unknown state.
• bndl—Port is attached to an aggregator and
bundled with other ports.
• susp—Port is in a suspended state; it is not
attached to any aggregator.
• hot-sby—Port is in a hot-standby state.
• indiv—Port is incapable of bundling with any
other port.
• indep—Port is in an independent state (not
bundled but able to handle data traffic. In this
case, LACP is not running on the partner port).
• down—Port is down.
State
Port priority setting. LACP uses the port priority to
put ports in standby mode when there is a hardware
limitation that prevents all compatible ports from
aggregating.
LACP Port Priority
Administrative key assigned to this port. LACP
automatically generates an administrative key value
as a hexadecimal number. The administrative key
defines the ability of a port to aggregate with other
ports. A port’s ability to aggregate with other ports is
determined by the port physical characteristics (for
example, data rate and duplex capability) and
configuration restrictions that you establish.
Admin Key
Runtime operational key that is being used by this
port. LACP automatically generates this value as a
hexadecimal number.
Oper Key
Port number.Port Number
Catalyst 2960-X Switch Layer 2 Command Reference, Cisco IOS Release 15.0(2)EX
60 OL-29043 -01
Layer 2 Commands
show lacp

Cisco Catalyst 2960-X Specifications

General

Console port	RJ-45
USB 2.0 ports quantity	2
SFP module slots quantity	4
Installed SFP modules quantity	-
Gigabit Ethernet (copper) ports quantity	48
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Power source	AC
Input current	5 A
AC input voltage	100 - 240 V
Power consumption (typical)	60.9 W
Number of power supply units	1
Redundant power supply (RPS) support	Yes
Operating altitude	0 - 3000 m
Non-operating altitude	0 - 4000 m
Storage temperature (T-T)	-25 - 70 °C
Operating temperature (T-T)	-5 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Switching protocols	UDP, TCP, RADIUS/TACACS+
Number of VLANs	1023
Networking standards	IEEE 802.1ab, IEEE 802.1D, IEEE 802.1p, IEEE 802.1Q, IEEE 802.1s, IEEE 802.1w, IEEE 802.1x, IEEE 802.3, IEEE 802.3ab, IEEE 802.3ad, IEEE 802.3ae, IEEE 802.3af, IEEE 802.3ah, IEEE 802.3at, IEEE 802.3az, IEEE 802.3u, IEEE 802.3x, IEEE 802.3z
Throughput	107.1 Mpps
Jumbo frames	9216
Number of queues	8
MAC address table	16000 entries
Number of static routes	1000
DHCP features	DHCP server
Authentication	MAC-based authentication, Port-based authentication
Security algorithms	802.1x RADIUS, SNMP, SSH
Access Control List (ACL) rules	3
Switch type	Managed
Switch layer	L2/L3
Safety	UL 60950-1, CAN/CSA-C22.2 No. 60950-1, EN 60950-1, IEC 60950-1, AS/NZS 60950-1
Form factor	1U
Product color	Black
Total Power over Ethernet (PoE) budget	370 W
Power over Ethernet (PoE) ports quantity	24
Power over Ethernet plus (PoE+) ports quantity	12
Memory type	DRAM
Noise level	39 dB
Flash memory	128 MB
Internal memory	512 MB
Processor frequency	600 MHz
Mean time between failures (MTBF)	276870 h

Weight and Dimensions

Depth	368 mm
Width	445 mm
Height	45 mm
Weight	5800 g