Cisco Catalyst 2960-X - Show Platform Spanning-Tree

show platform spanning-tree
To display platform-dependent spanning-tree information, use the show platform spanning-tree privileged
EXEC command.
show platform spanning-tree synchronization [detail | vlan vlan-id]
Syntax Description
Displays spanning-tree state synchronization information.synchronization
(Optional) Displays detailed spanning-tree information.detail
(Optional) Displays VLAN switch spanning-tree information for the specified
VLAN. The range is 1 to 4094.
vlan vlan-id]
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS 15.0(2)EX
Usage Guidelines
Use this command only when you are working directly with your technical support representative while
troubleshooting a problem. Do not use this command unless your technical support representative asks you
to do so.
Catalyst 2960-X Switch Layer 2 Command Reference, Cisco IOS Release 15.0(2)EX
70 OL-29043 -01
Layer 2 Commands
show platform spanning-tree