Cisco Catalyst 3650 - Configuring the Device Web GUI

Initial Switch Configuration
Assign Initial Management Information
26
Best Practice User Guide for the Catalyst 3850 and Catalyst 3650 Switch Series
Note Enter the show running-configuration command to display the initial management information for the
switch.
! Use “show spanning-tree vlan 100” to confirm VLAN 100 FWD on the uplink
! interface.
! Use “show interface trunk” to confirm GigabitEthernet 1/1/1 is
! operating in Trunk mode correctly.
show spanning-tree vlan 100
VLAN0100
Spanning tree enabled protocol rstp
Root ID Priority 32868
Address 0022.bdd9.4c00
Cost 4
Port 49 (GigabitEthernet1/1/1)
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Bridge ID Priority 32868 (priority 32768 sys-id-ext 100)
Address 20bb.c05f.b300
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Aging Time 300 sec
Interface Role Sts Cost Prio.Nbr Type
------------------- ---- --- --------- --------
--------------------------------
Gi1/1/1 Root FWD 4 128.49 P2p
Gi1/1/2 Altn BLK 4 128.50 P2p
show interfaces trunk
Port Mode Encapsulation Status Native vlan
Gi1/1/1 on 802.1q trunking 999
Gi1/1/2 on 802.1q trunking 999
Port Vlans allowed on trunk
Gi1/1/1 1-4094
Gi1/1/2 1-4094
Port Vlans allowed and active in management domain
Gi1/1/1 1,100,999
Gi1/1/2 1,100,999
Port Vlans in spanning tree forwarding state and not pruned
Gi1/1/1 1,100,999
Gi1/1/2 none
!
! Now the default gateway will respond to pings
!
ping 182.168.1.1