Cisco Catalyst 3650 - Show Running Configuration for Provisioning Modes

Access Control on the Wired Network
Show Running Configuration for Provisioning Modes
74
Best Practice User Guide for the Catalyst 3850 and Catalyst 3650 Switch Series
Show Running Configuration for Provisioning Modes
Step 1 Enter the show running-configuration command to display provisioning modes for the switch.
Figure 10 show running-configuration command for Provision in Monitor Mode
show running-configuration
hostname 3850-access-Bld1Flr1
!
!
aaa new-model
!
aaa authentication dot1x default group radius
!
ip device tracking
!
!
dot1x system-auth-control
!
!
interface GigabitEthernet1/0/1
switchport access vlan 10
switchport mode access
switchport block unicast
switchport voice vlan 11
ip arp inspection limit rate 100
trust device cisco-phone
authentication host-mode multi-auth
authentication open
authentication port-control auto
mab
dot1x pae authenticator
storm-control broadcast level pps 1k
storm-control multicast level pps 2k
storm-control action trap
Ipv6 nd raguard attach-policy endhost_ipv6_raguard
Ipv6 guard attach-policy endhost_ipv6__guard
auto qos voip cisco-phone
service-policy input AutoQos-4.0-CiscoPhone-Input-Policy
service-policy output AutoQos-4.0-Output-Policy
ip verify source
ip snooping limit rate 100
!
!
radius server AuthServer
address ipv4 192.168.254.14 auth-port 1645 acct-port 1646
key cisco123
!