Cisco Systems, Inc.
www.cisco.com
Global System Configuration
This workflow describes common global configurations for all switch deployments in the access layer.
Prerequisites for Global System Configuration
• Complete the task described in “Initial Switch Configuration” workflow.
• If you have not completed the task described in the “Uplink Interface Connectivity” workflow, the
switch might not be IP reachable. If that is the case, use only the switch console to perform the
Global System Configuration workflow.
If you have completed the “Uplink Interface Connectivity” workflow, you can perform the Global
System Configuration workflow using the switch console, SSH, or any management tool. Using
tools other than the console requires you to log in using user names and passwords configured, as
described in the section the “Initial Switch Configuration” workflow.
Identify Configuration Values
We recommend that you identify certain switch configuration values in advance so that you can proceed
with this workflow without interruption. We recommend that you take a print out of Table 4, and, as you
follow the configuration sequence, you should replace the values in column B with your values in
column C.
Note Replace the blue italicized example values with your own values.
Table 4 Global System: Setting Values
A. Value Name B. Example Value C. Your Value
Management subnets allowed
192.168.128.5/0.0.0.255
192.168.0.0/0.0.0.255
192.168.254.0/0.0.0.255
NTP server IP address
192.168.254.11
To Next Page
Loading...
Need help?
General
