Cisco Catalyst 3650 - Configuring the Device Web GUI

debug platform pm
To enable debugging of the platform-dependent port manager software module, use the debug platform pm
command in privileged EXEC mode. To disable debugging, use the no form of this command.
debug platform pm {all| counters| errdisable| fec| if-numbers| l2-control| link-status| platform| pm-spi|
pm-vectors [detail]| ses| vlans}
no debug platform pm {all| counters| errdisable| fec| if-numbers| l2-control| link-status| platform| pm-spi|
pm-vectors [detail]| ses| vlans}
Syntax Description
Displays all port manager debug messages.all
Displays counters for remote procedure call (RPC) debug messages.counters
Displays error-disabled-related events debug messages.errdisable
Displays forwarding equivalence class (FEC) platform-related events
debug messages.
fec
Displays interface-number translation event debug messages.if-numbers
Displays Layer 2 control infra debug messages.l2-control
Displays interface link-detection event debug messages.link-status
Displays port manager function event debug messages.platform
Displays port manager stateful packet inspection (SPI) event debug
messages.
pm-spi
Displays port manager vector-related event debug messages.pm-vectors
(Optional) Displays vector-function details.detail
Displays service expansion shelf (SES) related event debug messages.ses
Displays VLAN creation and deletion event debug messages.vlans
Command Default
Debugging is disabled.
Command Modes
Privileged EXEC
Layer 2/3 Command Reference, Cisco IOS XE Release 3.6E (Catalyst 3650 Switch)
34 OL-32639-01
Layer 2/3 Commands
debug platform pm