Cisco Catalyst 3650 - Show Platform Etherchannel

show platform etherchannel
To display platform-dependent EtherChannel information, use the show platform etherchannel command
in privileged EXEC mode.
show platform etherchannel channel-group-number {group-mask| load-balance mac src-mac dst-mac [ip
src-ip dst-ip [port src-port dst-port]]} [switch switch-number]
Syntax Description
Channel group number. The range is 1 to 128.
channel-group-number
Displays EtherChannel group mask.group-mask
Tests EtherChannel load-balance hash algorithm.load-balance
Specifies the source and destination MAC addresses.
mac src-mac dst-mac
(Optional) Specifies the source and destination IP addresses.
ip src-ip dst-ip
(Optional) Specifies the source and destination layer port numbers.
port src-port dst-port
(Optional) Specifies the stack member.
switch switch-number
Command Default
None
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
Use this command only when you are working directly with a technical support representative while
troubleshooting a problem.
Do not use this command unless a technical support representative asks you to do so.
Layer 2/3 Command Reference, Cisco IOS XE Release 3.6E (Catalyst 3650 Switch)
66 OL-32639-01
Layer 2/3 Commands
show platform etherchannel