Cisco Catalyst 3650 - Show Etherchannel

show etherchannel
To display EtherChannel information for a channel, use the show etherchannel command in user EXEC
mode.
show etherchannel [channel-group-number | {detail | port | port-channel | protocol | summary }] | [detail|
load-balance | port| port-channel| protocol| summary]
Syntax Description
(Optional) Channel group number. The range is 1 to 128.
channel-group-number
(Optional) Displays detailed EtherChannel information.detail
(Optional) Displays the load-balance or frame-distribution
scheme among ports in the port channel.
load-balance
(Optional) Displays EtherChannel port information.port
(Optional) Displays port-channel information.port-channel
(Optional) Displays the protocol that is being used in the
channel.
protocol
(Optional) Displays a one-line summary per channel group.summary
Command Default
None
Command Modes
User EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
If you do not specify a channel group number, all channel groups are displayed.
In the output, the passive port list field is displayed only for Layer 3 port channels. This field means that the
physical port, which is still not up, is configured to be in the channel group (and indirectly is in the only port
channel in the channel group).
Examples
This is an example of output from the show etherchannel channel-group-number detail command:
Switch> show etherchannel 1 detail
Group state = L2
Ports: 2 Maxports = 16
Layer 2/3 Command Reference, Cisco IOS XE Release 3.6E (Catalyst 3650 Switch)
56 OL-32639-01
Layer 2/3 Commands
show etherchannel