Cisco Catalyst 3650 Command Reference

show platform pm
To display platform-dependent port manager information, use the show platform pm command in privileged
EXEC mode.
show platform pm {etherchannel channel-group-number group-mask| interface-numbers| port-data
interface-id| port-state| spi-info| spi-req-q}
Syntax Description
Displays the EtherChannel group-mask table for the specified
channel group. The range is 1 to 128.
etherchannel channel-group-number
group-mask
Displays interface numbers information.interface-numbers
Displays port data information for the specified interface.
port-data interface-id
Displays port state information.port-state
Displays stateful packet inspection (SPI) information.spi-info
Displays stateful packet inspection (SPI) maximum wait time for
acknowledgment.
spi-req-q
Command Default
None
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
Use this command only when you are working directly with your technical support representative while
troubleshooting a problem.
Do not use this command unless your technical support representative asks you to do so.
Layer 2/3 Command Reference, Cisco IOS XE Release 3.6E (Catalyst 3650 Switch)
OL-32639-01 67
Layer 2/3 Commands
show platform pm

Cisco Catalyst 3650 Specifications

General

Switching Capacity	160 Gbps
Uplink Interfaces	4 x 1G SFP or 2 x 10G SFP+
Device Type	Switch
Form Factor	Rack-mountable
Layer	Layer 3
DRAM	4 GB
Flash Memory	4 GB
Operating System	Cisco IOS XE
Model	Catalyst 3650
Ports	24 or 48 10/100/1000 Ethernet ports
Stacking	Yes
Power over Ethernet (PoE)	Yes
Power Supply Options	350W AC
VLANs	4094