Cisco Catalyst 3650 Command Reference

port-channel load-balance
To set the load-distribution method among the ports in the EtherChannel, use the port-channel load-balance
command in global configuration mode. To reset the load-balancing mechanism to the default setting, use the
no form of this command.
port-channel load-balance {dst-ip| dst-mac| dst-mixed-ip-port| dst-port| extended| src-dst-ip| src-dst-mac|
src-dst-mixed-ip-port| src-dst-port| src-ip| src-mac| src-mixed-ip-port| src-port}
no port-channel load-balance
Syntax Description
Specifies load distribution based on the destination host IP address.dst-ip
Specifies load distribution based on the destination host MAC address. Packets
to the same destination are sent on the same port, but packets to different
destinations are sent on different ports in the channel.
dst-mac
Specifies load distribution based on the destination IPv4 or IPv6 address and the
TCP/UDP (Layer 4) port number.
dst-mixed-ip-port
Specifies load distribution based on the destination TCP/UDP (Layer 4) port
number for both IPv4 and IPv6.
dst-port
Sets extended load balance methods among the ports in the EtherChannel. See
the port-channel load-balance extended command.
extended
Specifies load distribution based on the source and destination host IP address.src-dst-ip
Specifies load distribution based on the source and destination host MAC address.src-dst-mac
Specifies load distribution based on the source and destination host IP address
and TCP/UDP (layer 4) port number.
src-dst-mixed-ip-port
Specifies load distribution based on the source and destination TCP/UDP (Layer
4) port number.
src-dst-port
Specifies load distribution based on the source host IP address.src-ip
Specifies load distribution based on the source MAC address. Packets from
different hosts use different ports in the channel, but packets from the same host
use the same port.
src-mac
Specifies load distribution based on the source host IP address and TCP/UDP
(Layer 4) port number.
src-mixed-ip-port
Specifies load distribution based on the TCP/UDP (Layer 4) port number.src-port
Layer 2/3 Command Reference, Cisco IOS XE Release 3.6E (Catalyst 3650 Switch)
50 OL-32639-01
Layer 2/3 Commands
port-channel load-balance

Cisco Catalyst 3650 Specifications

General

Switching Capacity	160 Gbps
Uplink Interfaces	4 x 1G SFP or 2 x 10G SFP+
Device Type	Switch
Form Factor	Rack-mountable
Layer	Layer 3
DRAM	4 GB
Flash Memory	4 GB
Operating System	Cisco IOS XE
Model	Catalyst 3650
Ports	24 or 48 10/100/1000 Ethernet ports
Stacking	Yes
Power over Ethernet (PoE)	Yes
Power Supply Options	350W AC
VLANs	4094