Cisco Catalyst 3650 - Page 47

Examples
This example shows how to configure the LACP port priority on a port:
Switch# interface gigabitethernet2/0/1
Switch(config-if)# lacp port-priority 1000
You can verify your settings by entering the show lacp [channel-group-number] internal privileged EXEC
command.
Related Commands
DescriptionCommand
Assigns an Ethernet port to an EtherChannel group, or enables an
EtherChannel mode, or both.
channel-group
Configures the LACP system priority.
lacp system-priority
Displays LACP channel-group information.
show lacp
Layer 2/3 Command Reference, Cisco IOS XE Release 3.6E (Catalyst 3650 Switch)
OL-32639-01 43
Layer 2/3 Commands
lacp port-priority